Our lot is near Mulholland. Can we still build a modern steel gate?

It depends on two things: whether the gate can be seen from Mulholland Drive, and whether the lot is within 500 feet of it. If both, the plan's materials apply — dark wrought iron or rough-cut wood among them — and a clean-lined black iron design often gives the modern look while staying on the list. Either way, the Mulholland review comes before the permit.

Our street is too narrow to wait on. Where should the gate go?

As far inside the property as the driveway allows, ideally at least one car length back from the curb so your car sits clear of the road while the gate opens. If the lot can't give that, a remote that starts the gate before you turn in, paired with a fast operator, shortens the wait to a moment.

We're next to Fryman Canyon Park. Does that change the review?

It can. For small projects the Mulholland plan offers a quicker staff-level clearance, but lots within 200 feet of parkland, 50 feet of a prominent ridge or 100 feet of a stream aren't eligible for it. Protected native trees near the gate also need a tree disclosure. And because wildlife moves through, we avoid gaps that can trap an animal.

Gates, garage doors, fencing & automation for Studio City homes and businesses

Custom Gate Installation & 24/7 Repair in Studio City, CA

Brown horizontal-slat metal driveway gate between pale walls

5.0
houzz5.0
yelp4.5
BBB A+

5.0 Stars on Google & Houzz — BBB A+ Accredited Since 2006

Near Mulholland the city limits what a visible gate can be made of, and on the canyon streets below there's rarely room for a car to wait — Studio City gates get drawn around both. Nothing is built until you approve the drawing. Our fabrication partner of 15 years builds it, our licensed installers put it in, and our phones are answered 24/7 for gate and garage door repairs.

Free On-Site Estimates
Custom Gates Since 2006
Licensed, Bonded & Insured

Get a Free Estimate

Free estimates in Studio City

Get Your Free Estimate

Tell us about the opening. We'll call to schedule a visit.

What do you need?

No obligation. It takes about a minute, then we call to schedule. Prefer to talk? (818) 782-6180

Gates in Studio City

What building a gate in Studio City actually involves

Studio City's hillside streets — off Laurel Canyon, up Coldwater, and along the ridges toward Mulholland — are where we build some of our most carefully engineered gates. Driveways are steep, openings are irregular, and there is often no room behind the gate to swing. Cantilever slide gates, custom-fit frames, and operators mounted where the terrain allows are the norm, and every one starts with a measurement and a drawing you approve.

Down in the flats, along the tree-lined streets near Ventura Boulevard and Tujunga Village, the work shifts toward curb appeal: horizontal cedar slats, black steel picket, wood on a steel frame that stays square through the summer heat. Studio City is inside the City of Los Angeles, so permits run through LADBS, and hillside parcels can require additional review. If yours needs a permit, we can handle it, billed separately.

We also see a lot of aging automation in Studio City — operators installed in the 1990s and 2000s that are slowing down, reversing, or dying after a power blip. Repairs are diagnosed on site with a written price, and if the operator is at the end of its life we show you the replacement numbers instead of patching it again.

Custom Gate Design Since 2006
Licensed, Bonded & Insured
Permit Help When You Need It
24/7 Emergency Gate Service
Free On-Site Estimates

Local conditions

What changes the build in Studio City

Within 500 feet of Mulholland
In the plan's inner corridor, a fence, gate or wall visible from Mulholland must be rough-cut unfinished wood, native stone, split-face block, textured plaster, or black or dark-green chain link or wrought iron. A painted modern slat gate isn't on that list, so lots near the ridge usually end up with dark iron or rough wood.
Canyon streets with no shoulder
Many streets off Laurel Canyon and Coldwater are barely wide enough for two cars to pass, so a car stopped at a closed gate blocks the road. We set the gate deep enough that the whole car clears the lane, pick an operator quick enough to keep the wait short, and put the keypad within a driver's reach.
Wood near the house in the fire zone
California's Zone 0 rules for the five feet around a house are not in effect: the Board of Forestry adopted emergency rules in August 2026 and withdrew them from state review that September. LAFD and County Fire already advise against combustible fencing at the house, so in the Studio City hills a side gate against the wall is built in steel, with a noncombustible run before any cedar fence begins.

Areas we cover in Studio City: Silver Triangle · Colfax Meadows · the Donas · Fryman Canyon Estates · Wrightwood Estates

Services

What we build and fix in Studio City

All services

Black double pedestrian gates with rings and scrollwork in a white entryway

Custom Wrought Iron GatesBlack or dark-green wrought iron, one of the materials the Mulholland plan accepts on gates visible from the drive.Learn More

Inside view of a brown double metal gate with actuator arms mounted near the paving

Automatic & Electric GatesOperators for steep canyon driveways, quick-cycling so a car spends as little time as possible waiting at the curb.Learn More

Double wood driveway gate with an arched top, dark hinges and decorative studs

Custom Wood GatesClear cedar and redwood on welded steel frames for the older houses of the Silver Triangle and Colfax Meadows.Learn More

24/7Gate RepairHinges, rollers and operators worn down by years on a steep drive, inspected in place and priced before any part is replaced.Learn More

Gate repair in Studio City

Garage doors in Studio City

Project photographs

Gates we've built

See all projects

Metal sliding driveway gate
Arched wood side gate
Swing gate operator

Rachel Cohen

6 years ago

“Had iron pedestrian gate installed at my parents house. The company was very professional, efficient and the price was very fair (we shopped around of course). I definitely recommend using this company A+ experience all around”

Nearby

Also serving the neighborhoods around Studio City

Studio City FAQ

Questions we hear in Studio City

Answers specific to Studio City. The questions every customer asks are on our FAQ page.

See All FAQs

A slide gate that runs along the fence line, or a cantilever gate that needs no ground track, usually solves it. If there is no room to slide either, a bi-fold gate folds as it opens. We measure the space at the estimate and draw the option that fits.

Free on-site estimate · Answered 24/7

Let’s Build Your Studio City Gate

Call now or send the form. A real person from our Van Nuys office will schedule your free visit and walk the opening with you.

Call (818) 782-6180

Free · No obligation

Tell Us About Your Project