Skip to content
Method Doors & Gates
Two pairs of pale carriage-style garage doors with black ring pulls below an iron balcony

Garage Door Opener Installation

Garage Door Opener Installation in Los Angeles

New and replacement openers chosen for your door and garage, with battery backup, tested safety sensors, and remotes set up around how your household comes and goes.

Plan the work with Method Gates

Get Your Free Estimate

Tell us about your garage door. We'll call to schedule a visit.

No obligation. It takes about a minute, then we call to schedule. Prefer to talk? (818) 782-6180

Garage Door Opener Installation

Match the opener to the door, the ceiling, and the room above

The right opener depends on the door it moves and the space around it. Chain, belt, and screw-drive openers hang from the ceiling and pull the door along a rail with a trolley. Wall-mount openers sit beside the door and turn its torsion bar instead, which keeps the ceiling clear. Noise matters if a bedroom sits over the garage. Headroom and ceiling space limit what fits, and the door's springs matter too, because wall-mount units need torsion springs.

We look at the door before the opener. Federal rules require opener instructions to call for a properly balanced door, with spring and cable repairs made before installation, and some older doors need that work first. SB 969 requires battery backup on every residential opener installed in California since July 1, 2019, so every opener we install at a home has it. We mount the opener, install the safety sensors with the beam no higher than 6 inches off the floor, set travel and force, test the reversal, and remove the old unit.

Price depends on the drive type, the features, the door, and any repairs it needs first, so we quote in writing after seeing the garage. If you also have an automatic driveway gate, tell us the gate operator's make. We install and repair gate operators too, so we look at both systems and check whether a single remote or car button can run them, setting up the controls together where the equipment allows.

  • Serving Los Angeles Since 2006
  • Licensed, Bonded & Insured
  • 24/7 Emergency Garage Door Service
  • Free On-Site Estimates
  • Gates & Garage Doors, One Company

Designs & details

Explore Garage Door Opener Installation

Project photographs alongside labeled design renderings and technical illustrations. Select an image for a closer look.

Service options

Opener drive types and features

  • Chain drive

    A steel chain pulls the trolley along the rail. Chain drives are the most common and least expensive type but louder than belt drives, so they suit detached garages and garages with no rooms above.

  • Belt drive

    A reinforced belt takes the place of the chain, so the opener runs quieter than a chain drive. It's the one to pick when a bedroom, office, or family room sits over the garage or shares a wall with it.

  • Screw drive

    A threaded steel rod turns to move the trolley, a design with fewer moving parts than a chain or belt drive. Genie, which makes them, calls screw drives temperature sensitive and doesn't recommend them where seasonal temperatures swing widely.

  • Wall-mount (jackshaft)

    Mounted beside the door, it turns the torsion bar directly, freeing the ceiling and suiting high-lift doors. It fits torsion-spring sectional doors only, not extension springs or one-piece doors, and it isn't a low-headroom fix.

  • Battery backup

    Mandatory under SB 969 for any residential opener installed in California on or after July 1, 2019. Chamberlain says it offers backup only on its DC-motor openers, since batteries supply DC power.

  • Smart control, remotes, and keypads

    Wi-Fi openers let you open, close, and check the door from a phone app, and many openers made after 1993 with safety sensors can be connected with a retrofit kit. We also set up remotes, an outdoor keypad, and compatible car buttons.

Which opener for which garage

A belt drive suits a garage with a bedroom over it, a wall-mount suits a ceiling you want kept clear, and a chain drive suits a detached garage. The spring system and the weight of the door narrow the choice from there.

Garage door opener drive types matched to the garage they suit
Your garageDrive type that suits itWhat to know
A bedroom, office, or family room above it or sharing a wallBelt driveIt runs quieter than a chain, so the room next to the motor and rail hears less of each trip.
Detached, or with no living space overheadChain driveLouder than a belt, which matters less when nobody is sleeping above it.
A ceiling you want left open for storage, racks, or lightingWall-mount (jackshaft)It sits beside the door and drives the torsion bar, so nothing hangs from the ceiling. It won't solve low headroom.
Torsion springs on a shaft above the doorChain, belt, screw, or wall-mountTorsion springs are the setup a wall-mount needs; we measure the clearance above the bar before recommending one.
Extension springs beside the tracks, or a one-piece tilt-up doorChain, belt, or screw drive on a railWall-mount openers fit torsion-spring sectional doors only.
A heavy door, such as solid wood or an oversized doubleBalanced springs first, then the drive that suits the roomThe springs carry the weight and the opener guides a balanced door, so a heavy door is a spring question before it's an opener question.

Honest pricing

How we price garage door opener installation

The drive type, the motor and its features, and the door it has to move set most of the price. A wall-mount unit, a Wi-Fi or camera model, extra remotes and a keypad, a new outlet, or spring work the door needs first each change the total. Those depend on your door and garage, so we price after seeing both.

Opener estimates are free, written, and itemized. We account for any door repair or electrical work and discuss permit responsibilities at the estimate.

Get Your Written Estimate

What sets the number

  • Drive type and motor
  • Door size, weight, and spring system
  • Wi-Fi, camera, and other built-in features
  • Number of remotes, keypads, and car buttons
  • Door repairs needed before the opener goes on
  • Outlet location and any new wiring

The proposal separates the work being recommended so you can review the scope before approving it.

What to expect

From choosing an opener to a tested installation

  1. Check the door and garage

    We check the door's balance, springs, and track, measure headroom and ceiling space, and note the outlet, the wall-control spot, and where the sensors will mount.

  2. Choose the opener

    We go over drive types, battery backup, and smart features, look at your gate's controls if you have one, and give you a written estimate to approve.

  3. Install and remove the old unit

    The old opener comes down. The new one is mounted, its wall control goes within sight of the door and at least 5 feet up, and the safety sensors go in.

  4. Set, test, and walk through

    We set travel and force, confirm the door reverses on a 2x4 laid flat, program your remotes and keypad, and show you how the battery backup works.

Reviews

What Customers Say About Working With Us

  • iris V

    6 years ago

    “We had gates installed by Method. They did such a great job. They gave us the best customer service and really tried to please us all the way. The job was well done at a reasonable price. I highly recommend this company.”

  • Brett Pacis

    4 years ago

    “Highly recommend! Fantastic team and service at Method Doors & Gates. They came immediately to my home, fixed the problem with my driveway gate and kept me updated throughout the process.”

  • Rachel Cohen

    6 years ago

    “Had iron pedestrian gate installed at my parents house. The company was very professional, efficient and the price was very fair (we shopped around of course). I definitely recommend using this company A+ experience all around”

Garage Door Opener Installation FAQ

Questions about garage door opener installation

Practical answers to help you plan the next step.

See All FAQs

Yes. SB 969, now Health and Safety Code §19892, requires battery backup on any residential garage door opener made for sale, sold, or installed in California on or after July 1, 2019, and the backup has to keep the opener working through a power outage. The law doesn't order older openers replaced, but a replacement door can't be connected to an existing opener without backup, however old the opener is. Run time on battery, and which features keep working, vary by model.

Free on-site estimate · Answered 24/7

Let’s Talk About Your Garage Door Opener Installation

Call now or send the form. A real person from our Van Nuys office will schedule your free visit and walk the opening with you.

Free · No obligation

Get Your Free Estimate

Tell us about your garage door. We'll call to schedule a visit.

No obligation. It takes about a minute, then we call to schedule. Prefer to talk? (818) 782-6180

Call NowGet a Quote