Batia Zelig
6 years ago
“I got my new gates with Method. I got excellent service. The job was well done, and the price was outstanding. Will definitely use them again.”
Commercial Fencing
Commercial Fence Installation in Los Angeles
Security, screening and perimeter fence for storage yards, industrial lots and apartment frontages, with the vehicle and walk gates planned into the same run.
Plan the work with Method Gates
Get Your Free Estimate
Tell us about the property and entrance. We'll call to discuss the scope.
No obligation. It takes about a minute, then we call to schedule. Prefer to talk? (818) 782-6180
Commercial Fencing
Commercial fence installation, planned stretch by stretch
A commercial fence is chosen stretch by stretch. The back line of a storage yard, its street frontage and the side beside the leasing office can each want a different fence, and every opening in the line, from a truck gate to a walk gate, has to be as hard to get through as the fence beside it. So we start with a walk of the whole perimeter rather than a panel catalog.
Security fencing works by delay and deterrence: it makes getting in slow, obvious and awkward rather than impossible. Federal criteria for security fences describe welded mesh, with openings too small for a toe or a finger, as harder to climb and cut than chain link, and ornamental steel as harder to climb than chain link as well. Which one fits depends on what the fence protects and who looks at it every day.
The steel picket and screening panels and gates are built to Method's drawing, and Method plans the run with the vehicle gates, walk gates and access control the property needs. Because the fence and its gates are drawn together, the posts at each gate are sized for that gate's weight, and the infill carries across the opening.
- Custom Gate Design Since 2006
- Licensed, Bonded & Insured
- Permit Help When You Need It
- 24/7 Emergency Gate Service
- Free On-Site Estimates
Designs & details
Explore Commercial Fencing
Project photographs alongside labeled design renderings and technical illustrations. Select an image for a closer look.
For owners, managers & contractors
Planning a commercial gate or perimeter project?
Explore project scopes for industrial properties, managed communities and storage facilities.
Perimeter fence types
A perimeter can mix types. The four below are the fences we build for commercial properties, compared by what each one does and where it fits.
| Fence type | What it does | Where it fits | What to specify |
|---|---|---|---|
| Security picket | Vertical steel pickets with the rails on the secure side, so the outside face offers nothing to stand on; flat, pointed or outward-bent tops | Industrial frontages, contractor and storage yards, and lots where staff need to see in and out | Picket size and spacing, height, top style, post size and footing depth |
| Anti-climb mesh or expanded metal | Welded mesh with openings too small for a toe or a finger, or expanded metal with small diamonds and wide strands; both resist climbing and cutting better than chain link and stay see-through | Equipment and fleet yards, utility areas, and the back line of a storage facility | Aperture and wire or strand size, panel height, and fixings that can't be undone from outside |
| Screening | Solid or slatted steel panels that hide stored material, equipment and trash enclosures from the street | Street-facing storage, equipment pads, and loading areas next to housing | How closed the infill is: a solid panel catches far more wind than open pickets, so the posts, their spacing and the footings grow with it |
| Ornamental multifamily | Steel picket fence detailed to belong to the building, with caps, finials and a finish matched to the railings, while still resisting climbing | Apartment, condominium and HOA frontages, courtyards and mixed-use entries | Picket spacing, the height allowed at the street, and self-closing walk gates on the residents' routes |
There is no single fence height for commercial land in Los Angeles County. The zoning code of the city or county where the parcel sits sets the limit, which can change at a street frontage, beside housing or within a required yard, and the building-permit question is separate again. We look up the parcel's rule before any height is drawn; our permit guide explains why those are two different checks.
Openings in the line are part of the fence. Anti-climb vehicle gates are on security gates, and walk gates with self-closers and electric locks are on pedestrian gates.
Working around an operating site
On an occupied property the work plan matters as much as the fence. It is agreed before the first post hole is dug, and it answers four questions.
- Which stretches come out first, so no part of the perimeter is left open overnight. Where the old fence can't stay up, the scope says what closes the gap and who provides it.
- Which entrances stay in service each day, and where deliveries, residents or staff go when one is closed for a gate change.
- What is under the line: utilities, irrigation and drainage are located before digging, and the post layout moves around them.
- When the work happens: hours set around shifts, deliveries and neighbors, with the work area kept clear of moving traffic.
Tell us at the walk about tenants, delivery windows and any alternate entrance. The phasing is written into the scope, ready to pass on to residents or staff before work starts.
Honest pricing
How we price commercial fencing
Commercial fence is priced by the linear foot for each fence type, and the gates and site work are added to that. Height and infill set the panel cost, post spacing and footings set the structure, and vehicle and walk gates also affect the total. The fence installation cost guide explains what a per-foot price should include.
Commercial fencing is quoted from the perimeter walk as a written scope, itemizing linear feet by fence type, each gate, removal of the old fence and the phasing.
Get Your Written EstimateWhat sets the number
- Height and infill
- Post spacing and footings
- Number and type of gates
- Site access and phasing
- Engineering and permit documentation
- Linear feet of each fence type
The proposal separates the work being recommended so you can review the scope before approving it.
What to expect
From a walk of the perimeter to a closed fence line
Walk the perimeter
We walk the full run with your site contact, noting grade changes, existing fence, utilities, drainage, the gates in use and where the line meets buildings and neighbors.
Choose by stretch
Each stretch gets a fence type, a height checked against the parcel's zoning rule, an infill and its gates, so security goes where it is needed and the frontage still looks right.
Scope and approval
The written scope gives linear feet by fence type, every gate, the footing approach and the phasing, ready for an owner, a board or a facilities manager to approve.
Permits and footings
The city decides whether the fence needs a building permit or engineered footings at its height. If it requires stamped drawings, we work with a structural engineer. When a permit is needed, we'll tell you who has to get it, and if you'd rather not deal with it, we can take care of it for an added fee. Those reviews clear before posts go in.
Install by phase
Posts and footings go in stretch by stretch, then panels, and the old fence comes out only as far as the new one can close the line. About 150 feet of fence usually takes 3–5 weeks from signed contract to finished job, and a large job 6–8 weeks.
Gates and handover
Vehicle and walk gates are hung and adjusted, operators and readers are connected (commercial gate access control), and keys and codes go to the site contact.
Reviews
What Customers Say About Working With Us
Virginia Longmuir
4 years ago
“I have used Method for repairs and upgrades to my driveway gate and garage door. They are always on time, courteous and the work is great.”
Hagit Eden
6 years ago
“I had the pleasure working with Method Doors & Gates, great prices, very professional and friendly, arrived on time, Replace my garage door, excellent job highly recommend.”
Commercial Fencing FAQ
Questions about commercial fencing
Practical answers to help you plan the next step.
It depends on the parcel. The zoning code of the city or county sets the limit, street frontages and lots next to homes can be treated differently from the back of an industrial site, and whether a building permit is needed is a different question from how tall the fence may be. The height is drawn only after the parcel's rule is confirmed.
Mesh is harder to climb and to cut and stays see-through, but it reads as industrial. A picket fence with its rails on the inside also resists climbing and looks finished on a street frontage. A site can use mesh along the back and pickets along the street, with gates to match; see security gates.
Yes. The work is phased so entrances stay usable and the perimeter is closed again before the site empties for the night, by the new fence, the old one, or a temporary closure named in the scope. Tell us about deliveries, residents and any alternate entrance at the site walk.
Because wind pushes on the closed area of the fence. The force on each post grows with the fence's height and the distance between posts, and it ends up in the footing and the soil, so a solid screen needs closer posts, larger posts or deeper footings than open pickets of the same height. Industry wind-load guidance also asks for each site to be assessed by a qualified engineer.
They should, in looks and in strength, because anyone testing a perimeter goes for the weakest opening, not the strongest panel. Vehicle gates and walk gates are built to the fence's height and infill, with locks and closers to suit. Vehicle gates can take an operator and readers (commercial gate access control), and walk gates are covered on pedestrian gates.
By the linear foot for each fence type, plus each gate, the removal of any old fence, and whatever site work the walk turns up, such as grade changes, difficult footings or paving to restore. The fence installation cost guide covers what a per-foot number should and shouldn't include.
Service area
Commercial Fencing across Los Angeles
From our office in Van Nuys we cover the San Fernando Valley, the Westside, and the neighborhoods in between.
- Bel Air, CA
- Beverly Hills, CA
- Brentwood, CA
- Burbank, CA
- Calabasas, CA
- Canoga Park, CA
- Chatsworth, CA
- Encino, CA
- Granada Hills, CA
- Hollywood, CA
- Lake Balboa, CA
- Los Angeles, CA
- Mission Hills, CA
- North Hills, CA
- North Hollywood, CA
- Northridge, CA
- Pacific Palisades, CA
- Pacoima, CA
- Panorama City, CA
- Porter Ranch, CA
- Reseda, CA
- San Fernando, CA
- Sherman Oaks, CA
- Studio City, CA
- Sun Valley, CA
- Sylmar, CA
- Tarzana, CA
- Universal City, CA
- Valley Village, CA
- Van Nuys, CA
- West Hills, CA
- West Hollywood, CA
- Woodland Hills, CA
Related services
Commercial GatesHeavy-duty slide and swing gates, security fencing, and access control for warehouses, multifamily buildings, and HOA communities.- Security GatesTall, anti-climb gate and fence systems for HOAs, multifamily, and industrial sites, with the access control the property needs.
Residential FencingIron, steel, and wood fencing that matches your gate, built from the same drawing.
Guides & answers
Commercial Gate & Fence Installation Costs in Los AngelesBuild a commercial project budget around the complete scope: gates, fencing, site work, controls, approvals and ongoing costs.
How to Compare Commercial Gate & Fencing ProposalsA practical bid comparison worksheet for owners, property managers and contractors: scope, equipment, exclusions, installation and handover.
Fence Installation Cost in Los Angeles: A Scope-First Budget GuideCompare materials, measure your fence run, and understand what a per-foot quote includes—with a clearly labeled sample budget.
Free on-site estimate · Answered 24/7
Let’s Talk About Your Commercial Fencing
Call now or send the form. A real person from our Van Nuys office will schedule your free visit and walk the opening with you.
Free · No obligation
Get Your Free Estimate
Tell us about the property and entrance. We'll call to discuss the scope.
No obligation. It takes about a minute, then we call to schedule. Prefer to talk? (818) 782-6180